He was referring, of course not only to the mess of wires behind where the CyberNavi used to be, but what they found as they began to remove the wiring.
|The initial exploration/planning stage. Note the left door panel is off as is the glovebox.|
That "best" has turned out to be not only "mediocre" (and now I suspect, judging by the date of install vs the date of product release, he installed used or prior year model parts) but in doing the install Nakamura not only damaged several parts, but he also threw out many parts on the car without asking me, and installed untested parts that might have led to long term damage. So clearly, this guy seems to have problems with judgment and common sense. But now NISMO, who's assigned their best electronics guy Uchida-san to the work, has confirmed my worst fears - that in doing his install, it appears Nakamura took a lot of short cuts, made illogical and irreversible decisions, and in some parts, even damaged other interior parts. Based on what I myself found earlier, I guess it's not surprising to find out that in areas that couldn't be readily seen, it was just as bad.
|Uchida-san trying to get a sense of the mess - note he's removed the seats|
|It might be a good idea, but not if you have to cut off essential brackets for a smooth install...|
Incidentally, here you can see the bracket that Nakamura jury rigged to hold the CyberNavi. So that enormously heavy piece of electronics was supported by 3 screws on the front, and nothing in back, with the unit itself resting on the sea of wires behind it. Unbelievable, really!
|From my prior post, where just looking at this pissed me off and I removed it.|
This one way thinking was also apparent in the speaker wiring - the original harness was gone, replaced by what appears to be slightly higher grade wiring. To be honest, I'm not too crushed about this, since I don't plan on reinstalling OEM speakers, and newer wiring, regardless of gauge, will likely be of a better quality than the old Nissan OEM wiring for purposes of sound quality. But, as with other items he removed from my car, Nakamura never asked me if he could cut and throw out the OEM wiring.
But more importantly, because he threw out the OEM speaker wiring and its connectors, it's no longer possible to use the OEM stereo harnesses which is what I wanted in bringing the car back to OEM condition. Having the OEM stereo harnesses and connectors would make it much easier to install aftermarket stereos, because there are adaptors that run between the aftermarket stereo and the connectors on the OEM speaker harness.
|Why didn't Worx use something like this? Photo from Amazon|
Uchida-san also found that the old Pioneer coaxials in the rear deck were not hooked up to anything. In fact, the wiring for these speakers seemed to be connected to CyberNavi leads that were labelled for the front? So as I hinted earlier, I asked them to reinstall these Pioneers in the doors, to replace the Morels that will be removed. This would allow me to easily first install an aftermarket stereo deck without worrying about a separate amp (these Pioneers were installed amp-less alongside with the old Pioneer deck I had, back in 2006), enjoy it for awhile, and then figure out what aftermarket speakers to get.
As for the alarm install itself, it turns out that Nakamura hacked into the main electrical harness (and likely, other harnesses such as for the doors and dome light) in places that don't make sense, meaning that in removing the alarm, they will have to be very careful to restore the harnesses to OEM condition. The concern is that without knowing what or where he hacked, simply cutting out the alarm might result in certain things not functioning. Alternatively, we could just install new harnesses, but this threatens to drive up the cost. Ochiai-san wanted my permission to let the alarm be and initially I agreed, due to time and cost considerations.
Friday morning, Ochiai-san sent me the following photo to show how Uchida-san was at the shop early, finishing the cleaning up of the stereo wiring mess. I'm curious to know his solution on the stereo output wires. Guess I will find out when I pick up the car...
|Note the seats are still gone but the left door inner panel has been replaced.|
In any case, by the end of the day Ochiai-san sent me this photo, showing how much cleaner it all looks now.
|Note, not only is much of the unecessary wiring gone, but the switch panel has been reinstalled.|
I'm sure you all want to know what happened when Ochiai-san called Worx... for that, you'll have to check out my next post tomorrow!